Operating parameters
You can use the following commands to configure and display the mode of operation for the
switch and display key parameters. The rules of syntax and output examples are all set out in
detail in the Reference Guide for the Avaya C360 Converged Stackable Switch, 10-300506.
Table 25: Operating Parameter CLI Commands
In order to...
Configure the basic mode of
operation of a module to either
Layer 2 or Router
Display the mode of operation
Display system parameters
Display module information for
all modules within the stack
Network Time Acquiring Protocols Parameter Configuration
The C360 can acquire the time from a Network Time Server. C360 supports the SNTP Protocol
(RFC 958) over UDP port 123 or TIME protocol over UDP port 37. Use the CLI commands
briefly described below for configuring and display time information and acquiring parameters.
The rules of syntax and output examples are all set out in detail in the Reference Guide for the
Avaya C360 Converged Stackable Switch, 10-300506.
In order to...
Restore the time zone to its
default, UTC.
Configure the time zone for the
system
Configure the time protocol for
use in the system
Enable or disable the time client
Configure the network time
server IP address
Display the current time
Basic Switch Configuration
Use the following command...
set device-mode
show device-mode
show system
show module
Use the following command...
clear timezone
set timezone
set time protocol
set time client
set time server
show time
1 of 2
Issue 1 July 2006
97