Static Routing Configuration Cli Commands; Route Preferences - Avaya C360 Installation And Configuration Manual

Avaya C360 Layer 3 Features

Static Routing Configuration CLI Commands

Route Preferences

The routing table may contain routes from different sources. Routes to a certain destination may
be learned independently from RIP and from OSPF, and at the same time, a static route can
also be configured to the same destination. While metrics are used to choose between routes of
the same protocol, protocol preferences are used to choose between routes of different
protocols.
The preferences only apply to routes for the same destination IP address and mask. They do
not override the longest-match choice. For example, a high-preference static default route will
not be preferred over a RIP route to the subnet of the destination.
170 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
In order to...
Establish a static route
Remove a static route
Set the maximum number of
route entries in the routing table
Set the maximum number of
route entries in the routing table
to the default value
Define a default gateway
(router)
Remove the default gateway
(router)
Delete all the dynamic routing
entries from the Routing Table
Display information about the IP
unicast routing table
Display a routing table for a
destination address
Display the static routes
Display the number of routes
known to the switch
Use the following command...
ip route
no ip route
ip max-route-entries
no ip max-route-entries
ip default-gateway
no ip default-gateway
clear ip route
show ip route
show ip route best-match
show ip route static
show ip route summary