Allowed Protocols; Allowed Protocols Introduction; Allowed Protocols Cli Commands - Avaya C360 Installation And Configuration Manual

Establishing Switch Access

Allowed Protocols

Allowed Protocols Introduction

With the Allowed Protocols feature, the network manager can determine the IP protocols
enabled on the switch. This feature can be used to block access to the switch using specific IP
protocols. Each protocol can be independently enabled or disabled on the switch.
Tip:
Enabling and disabling the Recovery Password protocol can only be done using
Tip:
a direct console connection via the Console port.

Allowed Protocols CLI Commands

The following Allowed Protocols commands are available.
Table 20: Allowed Protocol CLI Commands 1 of 2
86 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
In order to...
Enable Telnet on the switch
Disable Telnet on the switch
Enable HTTP on the switch
Disable HTTP on the switch
Enable the switch agent to
accept ICMP redirect packets
sent to it
Enable the switch agent to
ignore ICMP redirect packets
sent to it
Enable SNMP on the switch
Disable SNMP on the switch
Enable SNMPv1 switch access
Disable SNMPv1 switch access
Use the following command...
ip telnet enable
no ip telnet
ip http enable
no ip http
ip icmp redirect
no icmp redirect
snmp-server
no snmp-server
snmp-server community
no snmp-server community
1 of 2