Powering Up the Avaya C360
2. Connect the power cable to the terminals on the C360 and then external DC power supply.
!
WARNING:
Make sure that you connect the cables between the C360 and the external power
WARNING:
supply correctly:
Positive ("+") to positive ("+")
●
Negative ("-") to negative ("-")
●
!
ADVERTENCIA:
Asegúrese que las polaridades de los cables entre el C360 y la fuente de
ADVERTENCIA:
alimentación externa estén conectados correctamente:
Positivo ("+") a Positivo ("+")
●
Negativo ("-") a Negativo ("-")
●
3. Replace the plastic cover by aligning the holes with the screw receptacles and replacing the
two Phillips screws.
Supplemental Earthing of the C360 (Optional)
When connecting a BUPS to the C360, you must also connect a ground wire to the ground stud
provided on the rear of the unit. This ground conductor must be green/yellow, a minimum of 16
AWG and be terminated with a lug that is suitable for the M4 stud provided. The other end of the
ground conductor is to be terminated to a suitable building ground point such as a cold water
pipe.
54 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5