Installing And Removing A Sfp Gbic Transceiver - Avaya C360 Installation And Configuration Manual

Installation

Installing and Removing a SFP GBIC Transceiver

The SFP GBIC transceiver is fastened using a snap-in clip.
To install the SFP GBIC transceiver:
Insert the transceiver (take care to insert it the right way up) until it clicks in place.
●
Refer to Copper GBIC Transceiver Installation Notes
●
copper GBIC transceiver.
To remove the SFP GBIC transceiver:
1. Press the clip on the base of the transceiver see
Figure 15: Clip Location on Base of Transceiver
.
Figure notes:
1. Transceiver clip location
2. Pull the transceiver out.
Table 8: Gigabit Fiber Optic Cabling 1 of 2
Gigabit
Interface
1000BASE-SX
1000BASE-SX
1000BASE-SX
1000BASE-SX
1000BASE-LX
1000BASE-LX
46 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
1
Fiber Diameter Modal
Type (µm) Bandwidth
(MhzKm)
MM 62.5
MM 62.5
MM 50
MM 50
MM 62.5
MM 50
on page 47 if you are installing a
Figure 15 for the location.
Maximum Minimum
Distance Distance
(m) (m)
160 220
200 275
400 500
500 550
500 550
400 550
Wavelength
(nm)
2 850
2 850
2 850
2 850
2 1,310
2 1,310
1 of 2