Chapter 7: Switch Configuration; Introduction; Basic Switch Configuration - Avaya C360 Installation And Configuration Manual

Chapter 7: Switch Configuration

Introduction

This chapter describes the parameters you can define, such as its name and location, time
parameters, and so on. In addition, this chapter describes methods for saving and deploying
device configurations and monitoring CPU utilization.
This chapter contains the following sections:

Basic Switch Configuration

●
Uploading and Downloading Device Configurations and Images
●
SCP Protocol Support
●
System Logging
●
Telnet Client Support
●
Monitoring CPU Utilization
●
Basic Switch Configuration
Use the CLI commands briefly described below for configuring the display on your terminal or
workstation.The rules of syntax and output examples are all set out in detail in the Reference
Guide for the Avaya C360 Converged Stackable Switch, 10-300506.
Table 23: Basic Switch Configuration CLI Commands 1 of 2
In order to...
Open a CLI session to an entity
in the stack
Display or set the terminal width
(in characters)
Display or set the terminal
length (in lines)
Display or set the prompt
Use the following command...
session
terminal width
terminal length
hostname
1 of 2
Issue 1 July 2006 95