Avaya C360 Installation And Configuration Manual page 63

1. Use the serial cable supplied to attach the RJ-45 console connector to the Console port of
the master C360. Connect the DB-9 connector to the serial (COM) port on your PC/terminal.
- The master C360 is indicated by the SYS LED being ON.
2. Ensure that the serial port settings on the terminal are:
9600 baud
●
8 bits
●
1 stop bit
●
no parity.
●
- If you reset or powered up the switch after connecting and configuring the terminal,
Welcome to C360 appears followed by the Login Name prompt.
- If the login prompt does not appear, press a key on the terminal.
3. Enter the default login: root.
- The Password prompt appears
4. Enter the user level password: root.
- You can now establish a connection to the Router or the Master switch (indicated when
the SYS front panel LED is ON) using the Session commands and begin the
configuration of module, stack, or router parameters.
Establishing a Console Connection
Issue 1 July 2006 63