Lldp Agent Cli Commands - Avaya C360 Installation And Configuration Manual

LLDP Agent CLI Commands

The following table contains a list of the CLI commands for the LLDP Agent feature. The rules of
syntax and output examples are all set out in detail in the Reference Guide for the Avaya C360
Converged Stackable Switch, 10-300506.
In order to...
Enable or disable the LLDP
application globally (per stack).
Configure the interval at which
the device transmits LLDP
frames
Set the TxHoldMultiplier
Set the TxDelay
Set the reinitDelay
Display the global LLDP
configuration
Change the administrative lldp
port status
Enable or disable the
transmission of the optional TLVs
on a per-port basis
Display port-level lldp
configuration.
Display the VLAN-Name TLVs
that are being transmitted on a
specific port
Display the LLDP information
received on each port
Use the following command...
set lldp system-control
set lldp tx-interval
set lldp tx-hold-multiplier
set lldp tx-delay
lldp re-init-delay
show lldp config
set port lldp
set port lldp tlv
show port lldp config
show port lldp vlan-name config
show lldp
LLDP Agent
Issue 1 July 2006 149