Ssh Commands - Avaya C360 Installation And Configuration Manual

5. Using your SSH client software, open a session to the Stack Master IP address.
6. When you are prompted for a password, enter the User Level password root in lower case
letters (do not use uppercase letters).
- The User level prompt will appear when you have established communications with the
C360. You can now configure the C360 stack and change its default IP address.

SSH Commands

The following SSH commands are accessible from Supervisor level.
Table 15: SSH CLI Commands
In order to...
Enable SSH and configure SSH
parameters
Disable the SSH server
Display active SSH sessions on
the device. This command is
only available from the master
module switch context and from
all router contexts.
Disconnect an existing SSH
session. If an SSH session was
entered from the router, it can
only be disconnected from
router mode.
Generate an SSH host key pair
Establishing an SSH Connection
Use the following command...
ip ssh enable
no ip ssh
show ip ssh
disconnect ssh
crypto key generate dsa
Issue 1 July 2006 69