Menu Operation - OKIDATA ML320 Service Manual

4.10

MENU OPERATION

4.10.01 General Information
The end user can customize printer features by changing menu settings. These settings are
automatically activated when the printer is powered ON.
Selections made in Menu Mode are stored in the printer's permanent memory. They will stay
in effect, even when the printer is powered OFF.
software commands, the front panel, and by resetting the menu. Changes made by software
commands or the front panel are canceled when the printer is powered OFF.
Refer to Chapter 4 of the Printer Handbook information regarding the menu.
4.10.02 Limited Operation
In the Printer Menu, the sixth item in the General Control Group is Operator Panel
functions. The settings for this item are Full Operation and Limited Operation. A system
manager may use this feature to maintain proper print settings if the printer is part of
a customized system or if it is used by different operators.
When the Printer Menu is set to Limited Operation, the PRINT QUALITY, CHARACTER
PITCH, and MODE switches of the operator panel do not work.
To change from LIMITED OPERATION to FULL OPERATION, follow this procedure.
Verify that the ribbon and paper are installed.
Power OFF the printer.
Press and hold MODE while powering ON the printer.
Follow the normal menu procedures to set the Operator Panel Functions Item
to FULL OPERATION.
4.10.03 Printing the Menu
Verify that the ribbon and paper are installed.
Power ON the printer.
Press MODE. The SEL light will go out and the MENU lamp will light.
Press PRINT. The menu will print.
4.10.04 Modifying the Menu
Service Guide ML320/ML321
Chapter 4 Failure & Repair Analysis
However, they can be changed through
Page: 113