Ribbon Drive Assembly - OKIDATA ML320 Service Manual

3.2.14 Ribbon Drive Assembly

CAUTION: When handling the head cable, do NOT bend the cable at sharp angles
or you may damage it.
Perform these procedures first:
- 3.2.01 ( )
- 3.2.04 ( )
- Remove the ribbon (1).
- Insert a straight-slot screwdriver through the access slots and release the two front
claws (2) and the two rear claws (3) of the ribbon drive assembly (4).
- Lift and remove the assembly.
- Detach the head cable (5), the cable clamp (not shown) and the contact pressure rubber
(6) from the drive assembly.
Service Guide ML320/ML321
Chapter 3 Maintenance & Disassembly
Page: 61