Reset Spring, Change Gear, And Idler Gear - OKIDATA ML320 Service Manual

3.2.22 Reset Spring, Change Gear, and Idler Gear

CAUTION: - Please read through this entire procedure before performing it.
- Do NOT press against the vertical extension of the reset spring at any time
during this procedure.
- Firm pressure will release the reset spring, NOT brute force.
Perform these procedures first:
- 3.2.01 ( )
- 3.2.02 ( )
- 3.2.04 ( )
- Use a flat-blade screwdriver to press down at position A of the reset spring (1).
- Slide the spring out in the direction of arrow B.
- Detach the change gear (2).
- Detach the idler gear (3).
NOTE:
Lubrication
When lubricating, refer to Section 3.5 of this Service Handbook.
Parts Replacement
The Kit: Idler/Change Gear (ML300) includes the change and idler gears. Order
Service Guide ML320/ML321
Chapter 3 Maintenance & Disassembly
Page: 70