Paper Park - OKIDATA ML320 Service Manual

4.12 PAPER PARK

4.12.01 General Information
Paper Park allows single sheet paper to be printed without removing continuous feed paper
from the printer.
4.12.02 Procedure
Remove any printed pages.
Press PARK. The continuous feed paper will retract from the paper path. The ALARM lamp
will light and the SEL lamp will go out.
Move the paper lever to the Single Sheet Setting. This is towards the back of the printer.
Open the access cover.
Push the guide wire back into its locked position on the paper separator.
Raise the separator to its upright position.
Set a sheet of paper on the separator and adjust the guides. The guides should barely touch
the edges of the paper. Be sure to position the left edge of the paper even with the reference
mark on the separator.
Pull the bail lever forward. The paper will advance.
Push the bail lever back.
Adjust the Top of Form (if necessary). Refer to Section 4.11.
Print.
To return to continuous feed paper printing, perform the following.
Remove any printed pages.
Set the paper lever to continuous feed. This is towards the front of the printer.
Pull the bail lever forward. The paper will advance.
Push the bail lever back.
Adjust the Top of Form (if necessary). Refer to Section 4.11.
The unit is ready to print.
Service Guide ML320/ML321
Chapter 4 Failure & Repair Analysis
Page: 115