Fault Alarms - OKIDATA ML320 Service Manual

4.5 FAULT ALARMS

4.5.01 General Information
The operator panel is used to display printer modes and error conditions. The table below
shows the operator panel display and the mode or condition it matches.
Printer Modes - Rev A, B, and C
Alar SELEC MENU
m T Lamp
Lamp Lamp Status
Statu Status
s
OFF ON N/A
OFF ON N/A
OFF OFF N/A
OFF ON
ON OFF N/A
ON OFF N/A
ON OFF N/A
OFF BLINK N/A
Blink Off N/A
Service Guide ML320/ML321
Chapter 4 Failure & Repair Analysis
Printer Status
Mode
Normal On-Line
Operation
Normal Hex Dump
Operation
Normal Off-Line
Operation
Normal Menu Mode
Operation
Operator Paper End
Alarm
Operator Paper Jam
Alarm
Operator CSF Paper
Alarm Jam
Operator Print
Alarm Suppress
Fault Alarm
Description
The printer is ready to receive data
and to print.
The printer is in Hex Dump Mode.
Refer to Section 4.7 ( )
The printer will NOT receive data or
print.
The operator may view or change the
menu settings.
Printer is out of paper.
SASF paper jam
Paper jam or paper end with CSF
installed.
The printer has received a PRINT
SUPPRESS code
computer.
Page: 85
from the