Using The Setup Menus - Xantrex XW4024-120 Operation Manual

Configuration

Using the Setup Menus

Basic menu
Advanced menu
3–4
The XW Inverter/Charger configuration settings can be viewed in Basic and
Advanced formats (see Figure 3-3, "Basic and Advanced Settings" on page 3–6).
The Basic settings include configuration items you may have to adjust routinely,
or as part of initial setup.
The Advanced settings option gives you access to the full range of settings for the
XW Inverter/Charger, including everything displayed on the Basic menu. As a
safeguard against unintended advanced configuration, the XW Inverter/Charger
displays the Basic settings by default. To view the Advanced settings, you must
perform a special keypress.
WARNING: Risk of fire and shock hazard
The Advanced settings are intended for qualified installation/service personnel only.
Incorrect configuration can lead to battery damage and risk of fire.
Consult the local utility before changing any Grid Support settings. Before changing XW
Inverter/Charger settings, you must be familiar with the settings and the system-wide
impact of changing those settings. Setting these parameters incorrectly could damage
connected equipment (such as batteries) or could severely affect the performance of your
system.
To view the Advanced settings:
u Press Enter + up arrow + down arrow at the same time.
Notes:
• This keypress enables the Advanced settings for every device in the system.
• After performing the keypress, "Advanced Settings" appears at the top of the Setup
menu. When the keypress is performed again, the Setup menu displays "Basic
Settings" as the last item on the menu.
The XW Inverter/Charger Advanced settings include menus for configuring:
• Inverter settings (see page 3–7)
• Charger settings (see page 3–10)
• AC transfer limit settings (see page 3–16)
• Grid Support and Peak Load Shaving settings (see page 3–17)
• Generator Support settings (see page 3–21)
• Auxiliary output settings (see page 3–21).
• Multi-Unit Operation, including customizing the default model name of the
inverter/charger, and setting its network device number. Setting the device
number is important when multiple XW Inverter/Chargers are on the Xanbus
network and sharing connections such as AC loads, utility grid, and generator.
The device number is also used when configuring paralleled XW Inverter/
Chargers for master-slave operation (see page 3–7).
In the Advanced settings you can also copy another unit's settings using the
"Copy from" command.
975-0240-01-01