Copying Settings From Another Unit; Resetting The Xw Inverter/Charger To Default Settings - Xantrex XW4024-120 Operation Manual

Configuration

Copying Settings From Another Unit

Resetting the XW Inverter/Charger to Default Settings

3–28
The "Copy from" command allows quick configuration of an XW Inverter/
Charger. After selecting another XW Inverter/Charger in the system to copy
settings from, common parameters are copied from the selected XW Inverter/
Charger to the XW Inverter/Charger being configured.
The following settings are copied from the selected unit:
• Inverter Settings
• Charger Settings
• AC Settings
• Grid Support Settings (except the Sell setting)
• Gen Support Settings.
The following settings are not copied between units:
• Inverter Mode
• Device Instance
• Device Name
• Auxiliary Output settings.
The Restore Defaults command returns the XW Inverter/Charger to factory
default settings. After using the Restore Defaults command, the XW Inverter/
Charger is no longer configured for the power system.
To restore XW Inverter/Charger default settings:
1. On the Advanced Setup menu, select Restore Defaults.
Warning W252 appears, asking to confirm the Restore Defaults command.
2. To cancel the command, press Exit. To continue with the Restore Defaults
command, press Enter.
Important:
If a warning is already active in the system, selecting Restore Defaults
brings up the Warning List, with warning W252 at the top. Press Enter to view W252 and
continue with the Restore Defaults process.
CAUTION: Equipment damage
Do not use the Restore Defaults command while the XW Inverter/Charger is operating.
De-energize the power system and disconnect the XW Inverter/Charger AC input before
using the Restore Defaults command. Reconfigure the XW Inverter/Charger before
reconnecting the AC input and re-energizing the power system.
975-0240-01-01