Tiller Height Adjustment; Seat Adjustment / Dismantle - Invacare Scorpius-A Instruction Booklet

Scorpius-A

4.5 TILLER HEIGHT ADJUSTMENT

Loosen (counterclockwise) the screw knob to adjust
the tiller height. Tighten (clockwise) screw knob
again to lock at a desired position.
There is a stop point on the tiller, the height cannot
exceed the stop point (approx. 20 cm) (Figure 19).

4.6 SEAT ADJUSTMENT / DISMANTLE

•
Please refer to section 5 for scooter folding / unfolding.
•
When scooter is being folded, the seat latch will automatically release,
and seat will move backwards.
•
After unfolding, the seat shall automatically move forwards. However,
please always double check and manually push the seat to its locked
position if necessary.
•
Do not get on the scooter if the seat is positioned in red point (H). Get
on the scooter only if the seat is locked in its green point position
(Figure 20).
Seat Dismantle:
1. Loosen the screws (I) by wrench and hex key.
2. Press the springs (J) to remove from the seat slide bracket.
3. Pull down and hold the seat springs to release the seat latch (K).
4. Push the seat bracket (L) by thumbs towards the back of the scooter to release the seat from the
latch.
5. When the seat is released from the latch, grab the seat (L1) and push it towards the back of the
scooter to remove the seat.
❖ When putting the seat back, insert the seat back to the seat slide bracket. Push the seat towards the front
of the scooter (green point), fasten the screws (Figure 21) and insert the springs back to the seat slide
bracket (J).
❖ Please make sure to follow the direction of step 2 (Figure 22), shown when putting the springs (J) back to
the bracket. Otherwise, it may cause damage.
•
Do not conduct any adjustment (tiller / seat / armrest) while driving the scooter.
•
Do not get on the scooter until the seat firmly locks in the green point position.
•
Except for removing the seat, do not operate the seat springs if not necessary.
•
When pulling the seat springs, please grab and hold down springs on both sides. This helps the
user to easily release the seat latches. The latches may not be released if the holding point of
the seat springs is incorrect.
•
If there is any defect on a spring, please contact your dealer.
1654768~A_
Instruction Booklet
15