Removing/Installing The Front Wheel - Invacare Lynx L-4 User Manual

9 WHEELS AND CASTERS
Installing
1. Place keystock* in cutout on drive shaft as shown in FIGURE 9.1.
 * The keystock is not present on the front wheels of the Lynx L-4 scooters.
The keystock in the drive shaft MUST lineup with the cutout in the wheel hub.
If necessary, use a rubber hammer to gently tap drive wheel completely into position on the drive shaft.
2. Install the drive wheel onto the drive shaft.
3. Secure wheel to drive shaft using the mounting screw and washer. Securely tighten.
4. Repeat STEPS 1-3 to install the other drive wheel.
5. Install the seat. Refer to Removing/Installing the Seat on page 23.
9.2

Removing/Installing the Front Wheel

 For this procedure, refer to FIGURE 9.2.
This procedure applies to the Lynx L-3 only.
Take note of position and orientation of wheel and mounting hardware before removing.
Removing
1. Turn power off and remove the key from the ignition.
2. Place the front of the powered scooter up on blocks so that the
front wheel is off the ground.
3. Remove the mounting screw, locknut, two spacers and washer that
secure the front wheel to the fork.
4. Remove the front wheel from the fork.
Installing
1. Align the front wheel with the fork mounting holes.
2. Using the mounting screw, locknut, two spacers and washer, secure
the front wheel to the fork.
3. Securely tighten the front wheel mounting hardware.
Lynx™L-3 & Lynx L-4 Scooters
Fork
Mounting
Hole
Locknut
Washer
Spacer
FIGURE 9.2 Removing/Installing the Front Wheel
36
Fork
Fork
Mounting
Hole
Front
Wheel
Mounting
Screw
Spacer
Part No. 1143205