Table of Contents
Advertisement
2.1
Unpacking and Inspection
The CDM-800 Gateway Router and its Installation and Operation Manual are packaged and
shipped in a pre-formed, reusable cardboard carton containing foam spacing for maximum shipping
protection.
Inspect shipping containers for damage. If shipping containers are damaged, keep them until the
contents of the shipment have been carefully inspected and checked for normal operation.
Do not use any cutting tool that will extend more than 1 inch into the container.
This can cause damage to the router.
CAUTION
Unpack and inspect the router as follows:
Step
1
Cut the tape at the top of the carton indicated by
2
Remove the cardboard/foam space covering the router.
3
Remove the router, manual and power cord from the carton.
4
Save the packing material for storage or reshipment purposes.
5
Inspect the equipment for any possible damage incurred during shipment.
Note: If damage is evident, contact the carrier and Comtech EF Data immediately
and submit a damage report.
6
Check the contents against the packing list to verify completeness of the
shipment.
7
Refer to the following sections for further installation instructions.
Chapter 2. INSTALLATION
2–1
Procedure
OPEN THIS END
.
Advertisement
Table of Contents
Need help?
Do you have a question about the CDM-800 and is the answer not in the manual?