Table of Contents
Advertisement
2.1
Unpacking and Inspection
The CDM-840 Remote Router and its Installation and Operation Manual are packaged in a pre-
formed, reusable, cardboard carton containing foam spacing for maximum shipping protection.
Be sure to keep all shipping materials for the carrier's inspection.
IMPORTANT
Inspect shipping containers for damage. If the shipping containers are damaged, keep them until
the contents of the shipment have been carefully inspected and checked for normal operation.
Do not use any cutting tool that will extend more than 1" into the container and
cause damage to the unit.
CAUTION
Unpack and inspect the unit as follows:
Step
Description
1
Cut the tape at the top of the carton indicated by "OPEN THIS END."
2
Remove the cardboard/foam space covering the unit.
3
Remove the unit, manual, and power cord from the carton.
4
Save the packing material for storage or reshipment purposes.
5
Inspect the equipment for any possible damage incurred during shipment.
6
Check the equipment against the packing list to ensure the shipment is correct.
7
Refer to the following sections for further installation instructions.
Chapter 2. INSTALLATION
2–1
Advertisement
Table of Contents
Need help?
Do you have a question about the CDM-840 and is the answer not in the manual?