Telecommunications Terminal Equipment Directive; Ce Mark; Rohs Compliance; Emc (Electromagnetic Compatibility) Compliance - Comtech EF Data CDM-800 Installation And Operation Manual

CDM-800 Gateway Router
Preface
Operation in vehicles or other transportable installations that are equipped to provide a stable
environment is permitted. If such vehicles do not provide a stable environment, safety of the
equipment to EN60950 may not be guaranteed.

Telecommunications Terminal Equipment Directive

In accordance with the Telecommunications Terminal Equipment Directive 91/263/EEC, this
equipment should not be directly connected to the Public Telecommunications Network.

CE Mark

Comtech EF Data declares that the CDM-800 meets the necessary requirements for the CE Mark.

RoHS Compliance

This unit satisfies (with exemptions) the requirements specified in the European Union Directive on
the Restriction of Hazardous Substances, Directive 2002/95/EC, (EU RoHS).

EMC (Electromagnetic Compatibility) Compliance

In accordance with European Directive 89/336/EEC, the CDM-800 has been shown, by
independent testing, to comply with the following standards:
Emissions:
Immunity:
Additionally, the CDM-800 has been shown to comply with the following standards:
To ensure that the CDM-800 continues to comply with these standards,
observe the following instructions:
IMPORTANT
•
Connections to the L-Band Tx ports (Type 'N' female connectors) and 70/140 MHz Tx,
Clock Extension In, and Reference In/Out ports (Type 'BNC' female connectors) should
be made using a good quality coaxial cable.
•
All 'D' type connectors attached to the rear panel must have back-shells that provide
continuous metallic shielding. Cable with a continuous outer shield (either foil or braid,
or both) must be used, and the shield must be bonded to the back-shell.
•
The equipment must be operated with its cover on at all times. If it becomes necessary to
remove the cover, the user should ensure that the cover is correctly refitted before normal
operation commences.
EN 55022 Class B - Limits and methods of measurement of radio
interference characteristics of Information Technology Equipment.
(Also tested to FCC Part 15 Class B.)
EN 55024 – Information Technology Equipment: Immunity
Characteristics, Limits, and Methods of Measurement.
EN 61000-3-2 – Harmonic Currents Emission;
EN 61000-3-3 – Voltage Fluctuations and Flicker.
xii
Revision 0
MN-CDM800