Remote Commands And Queries - Comtech EF Data CDM-800 Installation And Operation Manual

CDM-800 Gateway Router
Appendix B
B.5

Remote Commands and Queries

As explained earlier in this appendix, serial remote monitor and control
is accomplished through use of a 'Controller' device – typically a PC
or ASCII dumb terminal. An example of such a device is shown to the
right. From this interface, the user may type 'help[cr]' or '?[cr]' to
display the CDM-800's available commands and queries, and to review
instructions for using the interface.
Note the following:
Column 'C' = Command; Column 'Q' = Query; columns marked 'X' designate instruction code as Command only, Query only, or Command/Query.
CODE C
DPW X
IG1 X
IG2 X
IPA X
LC1 X
LC2 X
MAC
Note – In the tables that follow, the following codes are used in the 'Response to Command' column (as per Sect. B.4.5):
= Message ok
* Message ok, but not permitted in current mode
! Invalid instruction
Q PAGE
B-6
X B-6
X B-6
X B-7
X B-7
X B-7
X B-7
CODE C Q
MG1 X
MG2 X
MLC X X
NPS X
SRC X X
SWC X X
? Received ok, but invalid arguments were found
# Message ok, but unit is not in Remote mode.
B–5
MN-CDM800
PAGE
B-7
B-7
B-8
B-8
B-8
B-8
Revision 0