Configuring Vpn Policies - Cisco Small Business RV220W Administration Manual

Configuring Virtual Private Networks and Security
Configuring VPNs
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV220W Administration Guide

Configuring VPN Policies

To configure a VPN policy:
Choose VPN > IPsec > IPsec Policies.
In the VPN Policies Table, click Add.
Enter the information in the following sections and press Save.
General Parameters
Enter a unique name to identify the policy.
Choose the Policy Type:
• Manual Policy—All settings (including the keys) for the VPN tunnel are
manually input for each end point. No third-party server or organization is
involved.
• Auto Policy—Some parameters for the VPN tunnel are generated
automatically. This requires using the IKE (Internet Key Exchange) protocol
to perform negotiations between the two VPN Endpoints.
To create an Auto VPN Policy, you need to first create an IKE policy and then add
the corresponding Auto Policy for that IKE Policy.
In the Remote Endpoint field, select the type of identifier that you want to provide
for the gateway at the remote endpoint: IP Address or FQDN (Fully Qualified
Domain Name).
In the NetBIOS field, check Enable to allow NetBIOS broadcasts to travel over the
VPN tunnel, or uncheck this box to disable NetBIOS broadcasts over the VPN
tunnel. For client policies, the NetBIOS feature is available by default.
5
112