Configuring Ipv6 Lan Properties - Cisco Small Business RV220W Administration Manual

Configuring Networking
Configuring the LAN
STEP 4
STEP 1
STEP 2
STEP 3
Cisco RV220W Administration Guide
• DHCP Relay—Choose this if you are using a DHCP relay gateway. The relay
gateway transmits DHCP messages between multiple subnets. Enter the
address of the relay gateway in the Relay Gateway field.
• None—Use this to disable DHCP on the VLAN.
In the LAN Proxy section, to enable the VLAN to act as a proxy for all DNS requests
and communicate with the ISP's DNS servers, check the Enable box.
Click Save.

Configuring IPv6 LAN Properties

In IPv6 mode, the LAN DHCP server is enabled by default. The DHCPv6 server
assigns IPv6 addresses from configured address pools with the IPv6 Prefix
Length assigned to the LAN.
To configure IPv6 LAN properties:
Choose Networking > LAN > IPv6 LAN Configuration.
Under LAN TCP/IP Setup, in the IPv6 address field, enter the IP address of the
Cisco RV220W. The default IPv6 address for the gateway is fec0::1. You can
change this 128-bit IPv6 address based on your network requirements.
Enter the IPv6 prefix length. The IPv6 network (subnet) is identified by the initial
bits of the address called the prefix. By default, the prefix is 64-bits long. All hosts
in the network have the identical initial bits for their IPv6 address; the number of
common initial bits in the network's addresses is set by the prefix length field.
2
44