Cisco Small Business RV220W Administration Manual page 113

Wireless-n network security firewall
Hide thumbs Also See for Small Business RV220W:
Table of Contents

Advertisement

Configuring Virtual Private Networks and Security
Configuring VPNs
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV220W Administration Guide
Local Traffic Selection and Remote Traffic Section
For both of these sections, configure the following settings:
Local/Remote IP—Select the type of identifier that you want to provide for
the endpoint:
-
Any—Specifies that the policy is for traffic from the given end point
(local or remote). Note that selecting Any for both local and remote end
points is not valid.
-
Single—Limits the policy to one host. Enter the IP address of the host
that will be part of the VPN in Start IP Address field.
-
Range—Allows computers within an IP address range to connect to the
VPN. Enter the Start IP Address and End IP Address in the provided
fields.
-
Subnet—Allows an entire subnet to connect to the VPN. Enter the
network address in the Start IP Address field, and enter the Subnet
Mask in the Subnet Mask field.
In the Start Address field, enter the first IP address in the range. If you selected
Single, enter the single IP address in this field and leave the End IP Address field
blank.
In the End Address field, enter the last IP address in the range.
If you chose Subnet as the type, enter the Subnet Mask of the network.
5
113

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents