Configuring The Wan For An Ipv6 Network; Setting The Routing Mode; Configuring Wan Settings - Cisco Small Business RV220W Administration Manual

Configuring Networking
Configuring the WAN
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
STEP 3
Cisco RV220W Administration Guide

Configuring the WAN for an IPv6 Network

To configure wide area network settings for your IPv6 network, perform the
following steps.

Setting the Routing Mode

In the left panel, under Networking, click IPv6.
Click Routing Mode.
Choose IPv4/IPV6 mode.
Click Save.
Click OK to allow the RV220W to reboot.

Configuring WAN Settings

In the left panel, choose Networking > WAN and select IPv6 WAN Configuration.
The next steps depend on the type of WAN connection you choose.
DHCPv6
Choose if your RV220W receives its dynamic IP address from the ISP using DHCP.
In the WAN Connection Type field, choose DHCPv6.
In the DHCPv6 Address Settings field, choose the type of address auto-
configuration:
• Stateless—An ICMPv6 discover message will originate from the RV220W
and is used for auto-configuration, rather than the RV220W contacting the
DHCP server at the ISP to obtain a leased address.
• Stateful—The RV220W connects to the ISP's DHCPv6 server for a leased
address.
Click Save.
2
33