Configuring Quality of Service
Configuring Traffic Selectors or Flows
Configuring Traffic Selectors or Flows
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco RV220W Administration Guide
After a profile has been created, it can then be associated with a traffic selector. To
create a traffic selector:
Choose QoS > Traffic Selectors.
In the Traffic Selectors Table, click Add.
Choose the bandwidth profile which will applied to this traffic. (See
Bandwidth Profiles, page
Choose a service from the list. Traffic flow rules will be applied to this service. (If
you do not see a service that you want, you can configure a custom service in the
Firewall page - see
Creating Custom Services, page
In the Traffic Selector Match Type field, choose the type of matching the
bandwidth profile will use before applying the traffic flow rules:
•
IP Address Range—Enter the starting and ending IP address ranges.
•
MAC Address—Enter the MAC address.
•
Port Name—Select the port on the router to which traffic rules will be
applied.
•
VLAN—Select the VLAN on the router to which traffic rules will be applied.
•
DSCP—Enter the DSCP value.
•
BSSIDs—Choose the Basic Service Set Identifier, or the MAC address of
the Wireless Access Point (WAP).
Click Save.
133.)
6
Configuring
89.)
134