Using The Vpn Wizard - Cisco Small Business RV220W Administration Manual

Configuring Virtual Private Networks and Security
Configuring VPNs
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco RV220W Administration Guide

Using the VPN Wizard

You can use the VPN wizard to quickly create both IKE and VPN policies. Once the
IKE or VPN policy is created, you can modify it as required.
To quickly set up a VPN tunnel using VPN Wizard:
Choose IPsec > VPN Wizard.
Choose the type of peer with which the VPN tunnel will connect:
• Gateway—A gateway tunnel is created to connect with another VPN
gateway. Choose this option if the RV220W will not act as the VPN server.
• VPN Client—The RV220W is set up to allow remote users to connect to its
VPN server using their PC and VPN client software.
Enter the New Connection Name. The new connection name is used for
management and identification purposes.
Enter the Pre-Shared key. The PSK is between 8 and 49 characters and must be
entered exactly the same in this field on the RV220W and the remote VPN client or
gateway. Double quotes (") are not allowed.
Choose the Remote Gateway Type—IP Address or Fully-Qualified Domain Name
(FQDN). You must choose the same type for the remote and local gateway.
Enter the Remote WAN IP Address or Internet Name (FQDN). Only enabled if you
are connecting to a gateway peer.
Choose the Local Gateway Type—IP Address or FQDN. You must choose the
same type for the remote and local gateway.
Enter the Local WAN IP Address or Internet Name (FQDN). This field can be left
blank if you are not using a different FQDN or IP address than the one specified in
the WAN port configuration.
5
106