Cisco Small Business RV220W Administration Manual page 14

Introduction
Mounting the Cisco RV220W
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV220W Administration Guide
To mount the firewall to the wall:
Determine where you want to mount the firewall. Verify that the surface is smooth,
flat, dry, and sturdy. Take into account the dimensions of the RV220W and allow for
3 inches (76.2 mm) of clearance around it.
For horizontal mounting, drill two pilot holes into the surface 5-7/8 inches (150 mm)
apart. For vertical mounting, drill two pilot holes into the surface 4-1/4 inches
(108 mm) apart.
Horizontal
Wall mount
slots
(Optional) If using drywall anchors, hammer into holes.
Insert a screw into each hole in the surface, leaving a gap between the surface
and the base of the screw head of at least 0. 1 inches (3 mm). Do not mount the
screw heads flush with the surface; the screw heads must fit inside the back of the
unit.
5-7/8"
RV220W
Wireless N Network Security Firewall
1
Vertical
Wall mount
slots
4-1/4"
14