Intermec CK61 User Manual page 70

Chapter 2 — Connecting and Configuring the CK61
58
a Set Authentication to Open if WEP keys are not required or to
Shared when WEP keys are required for association.
b Set Data Encryption to WEP.
c To change the network key, clear The key is automatically
provided check box, enter the new Network key, and then select
the appropriate Key index.
Follow these steps to enable WPA authentication:
a Set Authentication to WPA.
b Set Data Encryption to either WEP or TKIP.
Follow these steps to enable WPA authentication using a
preshared key:
a Set Authentication to WPA-PSK.
b Set Data Encryption to either WEP or TKIP.
c Enter the new Network key.
Follow these steps to enable WPA2 authentication:
a Set Authentication to WPA2.
b Set Data Encryption to AES or TKIP.
c Enter the new Network key.
Follow these steps to enable WPA2 authentication using a
preshared key:
a Set Authentication to WPA2-PSK.
b Set Data Encryption to AES or TKIP.
c Enter the new Network key.
5 From the EAP type list, select either PEAP or Smart Card or
Certificate and then tap Finish.
6 From the Networks to access list, select All Available, Only access
points, or Only computer-to-computer.
7 Tap OK to close the screen.
Note: If you select to automatically connect to non-preferred
networks, the CK61 detects any new networks and provides you with
the opportunity to configure them.
CK61 Handheld Computer User's Manual With Windows CE