Replacing Bushings - Husqvarna Rider 16C AWD Workshop Manual

5. Remove the hydrostatic transmission
cable from the arm and the casing from
the bracket.
6. Remove the circlip and lift off the
hydrostatic transmission's fan.
7. Remove the rear belt from the impeller
and the adjuster pulley.
8. Remove the circlip and washer from the
pendulum shaft and pull loose the rear
frame.
9. Remove the circlip and washer from the
pendulum shaft's inner mount (1) and
pull the shaft out to the rear. Use a
sledgehammer or puller if needed.
If the dust cover (2) is damaged, it
should be replaced with a new one.

Replacing Bushings

Once the pendulum shaft is removed, replace
the bushings in the rear frame.
Remove these with a punch, see "Special
Tools".
New bushings are fitted with the punch see
"Special Tools". Make sure that the bushing
grooves are lined up horizontally. It is
important that the outer bushing's outer edge
is on the same level as the outer edge of the
hole. The bushings should first be lubricated
with a lithium-based lubricant.
64
English-
REPAIR INSTRUCTIONS
Hydrostatic cable
Hydrostatic transmission's fan
Pendulum shaft
Replacing bushings
8009-822
8009-823
6012-031
8009-044