Removing/Fitting The Cable Pulley - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Steering cables and cable pulley

Removing/Fitting the Cable Pulley

1. Remove the frame plate.
2. Loosen the steering cables' rear mount (1).
3. Remove the screw (2) and remove the cable
pulley (5).
4. Remove the bearing's circlip (3) and tap out
the bearing (4).
5. To fit the cable pulley, follow the instructions
in the reverse order.
The screw (2) is to be mounted in the rear hole
on the frame. The bushing (6) is to be placed
between the frame and the cable pulley.
Ensure that the cables are properly situated
under the steering cable rollers (7) in the
frame tunnel.
Hold the cables with, for example, an
adjustable wrench when mounting so that
they do not twist.
After mounting, the cable tension should be
checked, see "Remove the frame plate by
loosening the screws (two on the power steering
housing)." on page 34.
Ensure that the steering wheel is in the centre posi-
tion when the rear wheels are centred. Reset the
chain on the power steering sprocket or adjust the
rear fixture for the steering cables (1) as needed.
There is a complete assembly kit for sale for the
Rider ProFlex that contains a cable pulley,
bushings, and bearings.
36
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Steering cable's rear mount, left side
Steering cable tension
8009-358
8009-341
6008-212