Mitel sx-100 User Manual page 90

SECTION MITL91 OS/91 lo-096-350-NA
Page 84
The interconnecting facilities between the RMAT Controller and
the RCP-installed systems. This communication's link is in most
cases provided by the public switched network, with the RMAT
Controller dialing up the required system. Access to each sys-
tem may be provided by dialing a dedicated number (trunk), or
by dialing the listed directory number for the system. A user
defined security code within each system provides protection
against unauthorized
Note: The RCP Card occupies slot 16, which might otherwise have
been used for a second console Control card. The system
then has a single Supervisor console. if, however, a second
Supervisor console is required together with the RMAT fa-
cility, then the second console is connected to the main-
tenance port. Under these conditions certain limitations are
imposed such as:
Shared HOLD positions between the two consoles.
Shared conference call setting capability.
No time-out to night service on the second console.
Audio connection between Supervisor consoles when both are
idle.
Separate console configuration in a tenant installation is not
possible.
3.03 Once the RCP card has been accessed the RMAT Controller can
perform the following functions at the system:
Duplication by the RMAT Console operator of the system nor-
mal Supervisor
speech path is available to the RMAT console operator once the
RCP is accessed.)
Programming functions for the remote system including ex-
tended programming for Multi-Digit Toll Control purposes.
Detection of alarm conditions at the system and the ability to
clear alarms, to busy out lines and trunks and perform reset and
system disable conditions.
If the RCP is connected as a system extension, the system
Supervisor, or any other system extension, has the facility of
originating an RMAT call to the RMAT Controller. In addition, if - .
the RCP extension has the COS option "Flash for Supervisor"
enabled, the RMAT operator can re-enter into speech mode :. % :
with the system Supervisor after being in the Remote Admin-
istration Mode.
access.
console functions and displays. (Note: No
.