Mitel sx-100 User Manual page 109

Modem Signaling Parameters:
Operation Mode
Data Rate
Transmit Tones
Transmit Level
Receive Tones
Receive Sensitivity
Line Interface Parameters:
On-hook DC Resistance
Ringing
Off-hook DC Resistance
Off-hook Impedance
Return Loss
Common Mode Rejection
Longitudinal Balance
Transient Protection
Power Supply and Digital
Interface Parameters:
TABLE 81-12
ELECTRICAL CHARACTERISTICS
REMOTE CONTROL-SYSTEM (RCP) CARD
Full or half duplex over 2-wire public switched network
with automatic answer feature
300 baud asynchronous
Mark 2225 Hz; Space 2025 Hz
Nominal -10 dBm with automatic gain to -3 dBm,
or + 0.4 dBm for loop attenuation compensation
Mark 1270 Hz; Space 1070 Hz
-4 to -45 dBm
Minimum 10 meg ohms
10 kohms in series with 'I PF
Minimum 30 Vrms at 20 Hz
260 ohms at 20 mA (line reversal ignored)
600 ohms in series with 2 PF
Minimum 14 dB at 200 Hz
25 dB at 1 kHz
35 dB at 3 kHz
60 Vrms maximum at 60 Hz
Minimum 63 dB at 1 kHz
56 dB at 13 kHz
Withstands 1000 V or lO/lOOO
resistance between Tip and ground or Ring and ground
Compatible with Console Control Card
(MITEL PN91 lo-006-OOO-NA)
SECTION MITL9105/911
0 dBm
Page B-l 3/l