Mitel sx-100 User Manual page 159

SECTION MITL91 OS/91 1 O-096-350-NA
I
TOLLS REQUIRED
1 flatblade screwdriver
1 Phillips screwdriver
(1.4)
Complete Steps (1) to (3F) of
MAP350-400
4
AND AND
EXPOSE THE EXPOSE THE
SYSTEM SYSTEM
AT REAR OF SYSTEM (FIGURE 402-l)
(2A) Remove the three screws that
hold the power supply to the
equipment shelf
(28) Remove the power supply
l-
-121 ' -121 '
- AND - AND
REMOVE POWER REMOVE POWER
SUPPLY SUPPLY
AT THE FRONT OF THE EQUIPMENT
(3A) Remove the eight 5-16 in.
retaining screws and finishing
washers
(38) Remove the equipment shelf
carefully sliding it forward
-I-
REMOVE THE REMOVE THE
REPLACE EQUIPMENT SHELF (SX-100)
MAP356- 462
Issue 3, May 1984
Sheet 1 of 5
POWER SUPPLV
RETAINING SCREWS (3)
EQUIPMENT
SHELF
//
CABLE SCREWS (4)
X1583
POWER SUPPLY
Figure 402-l
Power Supply Mounting
(Y)
Page D-15