Mitel sx-100 User Manual page 101

Station Loop Limit
Maximum Number of
Ringers per Line
Ringing:
Standard
Special
Ring Trip
Dial Tone
Transfer Dial Tone
Busy Tone
Special Busy Tone
Standard Ringback Tone
Special Ringback Tone
Callback
Reorder Tone
Conference Tone
Camp-On Tone
Override Tone
Crosstalk
Insertion Loss':
Station-to-Station
Station-to-Trunk
Trunk-to-Trunk
Longitudinal Balance
Return Loss
Idle Circuit Noise
Impulse Noise
Envelope Delay
System Impedance
Traffic Capacity
Primary Power
Central Office
Trunk Loop Limit
Maximum Distance of
Console from Equipment
Operating Environment
Maximum number
of SUPERSET 4 sets
TABLE Bl-2
SX-1 OO/SX-200 ELECTRICAL CHARACTERISTICS
SECTION MITL9105/911
200 ohms
1200 ohms including set
five
90 Vat, 20 Hz - immediate ringing
1 s on, 3 s off
0.5 s on, -0.5 s off, 0.5 s on, -2.5 s off
During silent or ringing period
Hz, continuous
Hz, 3 bursts of 100 ms, then continuous
Hz, interrupted at 60 ipm
440 Hz interrupted at 60 ips
Hz, 1 s on, 3 s off
2.5 s off
six rings of standard ringing
Hz, interrupted at 120 ipm
440 Hz, one burst of 1 s
440 Hz, one or two bursts of 200 ms
440 Hz, one burst of 900 ms followed by a
200 ms burst every 6 s
75 dB minimum
5 dB 20.5 dB at 1004 Hz
0.5 dB 50.3 dB at 1004 Hz
0.5 dB f0.3 dB at 1004 Hz
54 dB minimum, 200-3000 Hz
14 dB minimum
16 dBinC maximum
No counts over 46 dBrnC
150 fl maximum
600 ohms nominal for lines
600 or 900 ohms nominal for trunks
7.5 ccs/line minimum at 100 lines at P = 0.01
1600 ohms
300 m (1000 ft) of 26 AWG cable
0" C to 40°C (32°F to 104"F), 10 % to 90 %
Relative Humidity
64
Page B-5