Mitel sx-100 User Manual page 55

EXTENDED PROGRAMMlNG
Error
involved
Code
ANNOUNCE EQPT
E28
NUMBER
E30
E31
E32 NEW SET EQPT
NUMBER
E33 NEW SET EQPT
NUMBER
E33 NEW SET EQPT
E40
E42
TABLE 4-12 (CONT'D)
ERROR CODES - SUPERSET PROGRAMMING
Attempting to assign an equipment number as a Call
Announce Port when other equipment numbers previously
programmed for that slot identify the slot as other than a
Line card.
An attempt has been made to delete a Prime key (this is
equivalent to deleting the set) and a Non-Prime key on the
set was defined. Before a set can be deleted, all Non-Prime
keys must be undefined (deleted).
An attempt has been made to define a Non-Prime key when
the prime for the equipment number has not yet been
defined (the set itself has not been defined). The Prime key
must be the first key defined for a set.
When attempting to move a set the equipment number
specified cannot be moved as it is not programmed as a
When attempting to move a set to a new equipment number
that has been programmed already.
Attempting to move a SUPERSET
number when other equipment numbers previously
programmed for that slot identify the slot as other than a
A Prime key is being added, and the listed number is the
same as an existing primeless list. This can normally be
done, but in this case, the primeless list is not idle, so the
addition of the prime cannot be performed.
Addition of a key line appearance is attempted, but cannot be
performed because the listed number is not idle. Or, addition
of a DTS or private line was attempted, but cannot be
performed because the trunk chosen for the key is not idle.
An attempt has been made to delete a Prime key, but the
listed number is not completely idle. Note: All multiple call
appearances of a prime must be idle if the prime is to be
deleted; i.e., when a multiple call appearance 'somewhere' is
busy it will prevent prime deletion although the prime
appears idle. When this happens, use the Review mode to
find where all the appearances are, then delete each
individually. The busy one will cause an error.
SECTION MlTL91 OS/91 1 O-096-350-NA
Explanation
set to an equipment
Page 49