Mitel sx-100 User Manual page 47

Error
C o d e C a u s e Affected
E6 Incorrect
equipment
number entered.
E6 In extension EQPT NUMBER
mode, the
equipment
number is
assigned as: a
call announce
port, a
programmed
a single line set
with appearances.
E6 In trunk mode EQPT NUMBER
the trunk
selected has
appearances on
a SUPERSET set.
E7 System is busy. ENTER
Extension has a ENTER
message register
that is not zeroed
or has a message
waiting, or has
Do Not Disturb
set.
TABLE 4-5 (CONT'D)
STANDARD PROGRAMMING ERROR CODES
Flashing
None
None
None
None
None
SECTION MITL9105/91
Meaning
Attempting to assign
an equipment number
that is:
to an extension hunt
group or extension
a trunk group or a trunk
message registration to hunt
group or pickup group.
An equipment number
assigned to an extension
must be deleted as an
extension, before being
programmed as a trunk An
equipment number assigned
to a trunk must be deleted
as a trunk, before being
programmed as an
extension.
The equipment number
selected to be
programmed has already
been set programmed in
the SUPERSET set
programming as a
line set with appearances
or an announce port.
The trunk equipment
number already has
an appearance
on a SUPERSET set.
la) Attempting to initialize
a system while system is
in use.
data of an extension
or trunk while that extension
or trunk is in use. it must be
idle or busied-out.
register exists for
this extension.
message waiting or
Do Not Disturb set.
Action
Required
Remove conflicting
option:
(a) Assign equipment
number correctly
Enter correct
equipment number
or delete
conflicting
programming.
Delete appearances
on the SUPERSET set.
(a) Wait until system is
idle.
or trunk is idle.
Zero message register,
reset message waiting
or Do Not Disturb
and reprogram.
Page 41