Mitel sx-100 User Manual page 340

SECTION MITL9105/911 O-096-350-NA
::
L.1 ::
Line Select/Speed Call Buttons
11.13 There are three line select keys which can be configured (at the
time of programming) to select preassigned lines, in order to
receive or originate calls. In addition there are 12 Speed Call keys.
Hold Button
11.14 This button allows the set user to hold any call at the set.
The
line on which the call is held is indicated by the adjacent line
status display flashing on and off. The call may be retrieved by press-
ing the HOLD key.
Feature Buttons
11.15 There are six feature buttons. Each button is associated with a
specific feature. The user selects the feature, or action, by
pressing the appropriate feature button.
Supplementary Feature Buttons
(
if!+@
. :
.
-7:.
_.
11.16 Speaker on/off.
This button allows the set user to receive or
originate calls without use of the handset. Pressing the button
once switches the speaker and microphone on and selects the prime
line. Each time this button is pressed, the speaker and microphone are
switched alternately on and off, and the set is switched between on-
and off-hook conditions.
il.17 Mic on/off.
This switch is used to switch the microphone off
during handsfree operation, in order to either prevent transmis-
sion of local sound or improve reception when
the set is installed in a
noisy environment.
11.18 SWAP.
The SWAP key allows the user to effect a Broker's Call
between two calls.
11.19 TRANSXONF. This key allows the user to put a call on Hold,
dial a new number and conference the call or transfer the Call
on
Hold to the new number.
11.20 REDIAL.
This key when pressed automatically redials the last
manually dial trunk call.
11.21 CANCEL.
This key cancels any dial action performed at the
SUPERSET 3 set.
11.22 PROGRAM/SAVE. This key allows the user to program- and
save Speed Call dial numbers at specified speed dial key loca-
tions.
: . . . . c- :
:.: : .:
Page i-5