Mitel sx-100 User Manual page 191

PN191 O-350-502-NA SECTION MITL91 OS/91 1 O-096-350-NA
TOOL REQUIRED
1 flatblade screwdriver
:
(1A) Unlock and open front door
(16) Unlock and open rear door
(1C) Unlock and open rear panel
assembly
(1D) Set system power switch to OF
(1E) Set all power switches on rear
door to OFF
(1F) Set battery switch to OFF
(IG) Remove power cable(s) from
commercial AC source
AT REAR OF CABINET
(2A) Remove cables J13, J14, J15,
P16, P17, P18 and P19
(Figure 502-3)
(2B) Remove cable from RS-232
port (optional)
(2C) Remove OOT cable and
maintenance panel connectors
(2D) Remove power cable from
terminal block
Issue 3. May 1984
Sheet 1 of 7
-
AT THE REAR OF THE CABINET
(3A) Loosen cable clamps so that
the cables have approximately
25 cm (IO in.) of slack (Figure
502-l)
AT FRONT OF CABINET
(FIGURE 502-2)
(38) Unscrew eight l-4 X 3-8
retaining screws from the front
of the equipment shelves
(3C) Pull equipment shelves forward
approximately 5 cm (2 in.) _
J
c
REMOVE CABLES
(FIGURE 502-l)
PULL SHELVES
Page E-7