Configuring Bluetooth Communications - Intermec CN3 User Manual

Chapter 2 — Connecting and Configuring the CN3

Configuring Bluetooth Communications

50
• AD10 single dock with an Ethernet/modem (AA12/AA13) adapter
• AD11 Ethernet multidock
• AA16 Ethernet snap-on adapter
To use your CN3 in an Ethernet network
1 Connect the CN3 to an Ethernet network with an AD10, AD11, or
AA16. Ethernet communication is enabled by default on the CN3.
2 Configure these network parameters:
• If you have a DHCP server, enable DHCP.
• If you do not have a DHCP server, set these parameters:
a IP address
b Subnet mask
c Default router
3 If necessary, set these parameters:
Primary and secondary DNS servers
•
• Primary and secondary WINS servers
4 Make sure that your CN3 is communicating with the network and
that the network can see your CN3. For more information, see
"Managing Network Connections With iConnect" on page 54.
Your CN3 is Bluetooth™ enabled, which lets you connect to other
Bluetooth devices, such as scanners, printers, or audio devices.
You need to turn on the Bluetooth radio before you can discover and
connect to other Bluetooth devices. By default, the radio is turned off.
Use Intermec Settings to enable the radio and configure other
Bluetooth settings as described next.
To turn on the Bluetooth radio and configure Bluetooth settings
1 Start Intermec Settings.
2 Choose Communications > Bluetooth.
3 Choose On from the Power menu. A message appears asking if you
want to save the new settings.
CN3 Mobile Computer User's Manual for Windows Mobile 6.1