Intermec CN3 User Manual page 74

Chapter 2 — Connecting and Configuring the CN3
62
b Tap User Name, enter your user name, and press Enter.
c Tap User Password, enter your password, and press Enter.
d For Validate Server Certificate, choose Yes and press Enter.
Note: The correct date must be set on your CN3 when you
enable Validate Server Certificate.
If you choose TLS:
a Load a user and root certificate on your CN3. For help, see
"Loading a Certificate" on page 68.
b Enter a User Name and Subject Name.
c For Validate Server Certificate, choose Yes and press Enter.
d (Optional) To increase your level of security, enter a Server 1
Common name and a Server 2 Common name.
9 Save your settings and exit Intermec Settings.
To configure WPA or WPA2 with Funk security
1 Make sure the communications and radio parameters on your
CN3 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose WPA or WPA2 and press Enter.
7 For 8021x, choose None and press Enter.
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the CN3 internally converts it to a
pre-shared key.
This value must match the passphrase on the authenticator.
9 Save your settings and exit Intermec Settings.
CN3 Mobile Computer User's Manual for Windows Mobile 6.1