Using The Battery; Charging The Battery - Intermec CN3 User Manual

Chapter 1 — Using the CN3

Using the Battery

Charging the Battery

4
The CN3 Series computers use the following Intermec batteries as a
main power source. All have been certified to meet the IEEE 1725
standard for rechargeable batteries.
Standard and Extended Batteries for CN3 Series Computers
Computer Uses This Standard Battery
CN3 AB8 or AB15
CN3e N/A
CN3NI N/A
Standard batteries have 8.1 Watt hours capacity and extended
batteries have 14.8 Watt hours capacity. You must fully charge the
battery before you can use the CN3.
The battery used in this device may present a fire or chemical
burn hazard if it is mistreated. Do not disassemble it, heat it
above 100°C (212°F) or incinerate it.
If you fail to replace the low battery immediately, you may lose
important data or applications.
If the CN3 is not on external power and you remove the battery
pack, you need to install a charged battery within 5 minutes, or
the CN3 resets and you could lose data.
Dispose of used batteries promptly. Keep away from children. Contact
your Intermec representative for replacement batteries.
The battery pack should be fully charged before you use the CN3 for
the first time. If battery temperatures are within the battery charging
range of 0° to 40°C (32° to 104°F), the standard battery pack takes
up to four hours to charge. The extended battery pack takes up to five
hours.
CN3 Mobile Computer User's Manual for Windows Mobile 6.1
Uses This Extended Battery
AB9 or AB16
AB9 or AB16
AB28