Configuring The Backlight - Intermec CN3 User Manual

Configuring the Backlight

CN3 Mobile Computer User's Manual for Windows Mobile 6.1
To align the touch screen using the keypad
1 Press the Windows button on the upper left of the keypad.
2 Press the Down button to select Settings.
3 Press Enter.
4 Press the Tab button until the Settings tabs are highlighted.
5 Press the Right Arrow button to select the System tab (on some
keypads this will be the orange button and down button).
6 Press tab until the Screen icon is highlighted.
7 Tab to Align Screen and press Enter follow the instructions to
align the screen.
8 Click ok.
Note: If this procedure does not work, you can perform a clean boot,
which resets the screen but erases your data and applications. For
more information about performing a clean boot, see
the CN3" on page 100.
By default, the CN3 goes into Screen Off mode when there is no
activity on the computer. Screen Off mode turns off the backlight and
display. Press a key or tap the screen to resume activity.
It is possible to override the backlight settings by changing the power
management settings. For more information on configuring power
management, see "Managing Power on the CN3" on page 9.
To configure the backlight
1 Tap Start > Settings > the System tab > the Backlight icon > the
Battery Power tab.
2 With Turn off backlight if device is not used for checked, select
the timeout value (10 seconds, 30 seconds, or 1 to 5 minutes).
Chapter 1 — Using the CN3
"Clean Booting
23