Sagem MF 5890DN User Manual page 63

Setting your machine
The printer can be connected to the local network as it has its own IP address.
Updating network settings
The print console allows you to:
• Turn TCP/IP, NetWare and EtherTalk on or off.
• Turn DHCP on or off.
• Enter the IP address, the subnet mask address and the default gateway address.
To check or change the network card settings:
Press the
Repeatedly press the
One of the interface names below appears, showing that it is the current interface.
Press
Repeatedly press the keys
Press
Press the > key.
This example shows how to switch the TCP/IP protocol on to connect the terminal to the
network. You can switch Netware or EtherTalk on in the same way.
If TCP/IP is OFF. Press
Press
Automatically configuring IP settings
You can make these settings when the TCP/IP protocol is on. We recommend that you manually
configure your terminal. However, local network settings can be automatically configured if you
have a DHCP or BOOTP server on your local network which can dynamically distribute
addresses to peripherals on the LAN.
To automatically configure network local settings:
Press
Select
P
RINT FUNCTION SETTINGS
key.
MENU
or
• (default setting)
PARALLEL
• USB
• (when the network card is installed)
OPTIONAL
, a blinking "?" appears.
OK
.
OK
OK
again.
OK
, a blinking "?" appears.
OK
using the or
ON
keys until
INTERFACE
or until appears.
OPTIONAL
, a blinking "?" appears. Select
MENU - - INTERFACE > -
, then press .
OK
3-15
appears.
using the or
ON
- TCP/IP > DHCP
keys.