Table of Contents
Advertisement
Setting your machine
As delivered your fax is preset by default. However, you may adjust it to meet your requirements
by resetting the technical parameters.
To set the technical parameters:
Select the desired parameter and confirm with OK.
With the
press OK.
Parameter
1 - SCANNING
MODE
2 - TX HEADER
3 - TX SPEED
4 - ECHO PROTECT
6 - EPT MODE
7 - COM. DISPLAY
8 - ECO ENERGY
T
ECHNICAL PARAMETERS
or
keys, modify the parameter settings by following the table below and
Setting
1 - NORMAL
Default value of the scan mode resolution for the documents
2 - FINE
to be transmitted.
3 - SFINE
4 - PHOTO
1 - WITH
If this parameter is on, your header will appear on all
2 - WITHOUT
documents sent to your subscribers with your name, number,
date and number of pages.
Warning: If you send a fax from the document loader, the
transmission header will not appear on the document your
correspondent receives.
1 - 33600
Transmission speed for outgoing documents.
2 - 14400
For a quality telephone line (compatible, no echo),
3 - 12000
communications occur at maximum speed.
4 - 9600
However, it may be necessary to restrict the transmission
5 - 7200
speed for some calls.
6 - 4800
7 - 2400
1 - WITH
If this parameter is on, the on-line echo will be reduced during
2 - WITHOUT
long distance calls.
1 - WITH
For some long distance calls (satellite), the on-line echo may
2 - WITHOUT
disturb the call.
1 - SPEED
Choice between transmission speed displayed or number of
2 - PAGE NUMBER
the page in progress.
1 - WITHOUT
Choosing the printer standby delay: the printer will switch to
2 - DELAY
standby after a delay (in minutes) of NON-operation or during
5 MIN
the period of time of your choice.
3 - DELAY
15 MIN
4 - DELAY
30 MIN
5 - DELAY
60 MIN
Signification
3-9
29 OK - SETUP / TECHNICALS
Advertisement
Table of Contents
