Sagem MF 5890DN User Manual page 46

This section explains how to use the menu selection system. The [MENU] key on the operator console
allows you to use the menu to configure or adapt the printer environment, making settings such as the
number of copies to be made, the emulation, etc. depending on your own specific needs. You can make
these settings when the printer screen shows Ready.
Note: The printer applies the most recent settings sent from the application software or from the printer driver, and these
always take priority over any settings made from the operator console.
To navigate vertically within the functions, use the
repeatedly pressing one of the keys).
To navigate horizontally within the functions, use the > and < keys. To change or confirm the
configuration of a component, press the [OK] key.
Printing out the menu guide
The list of menus may vary according to which options you have installed.
You can print out the print menu guide by moving within the menus as shown below.
Press [OK], a blinking "?" appears.
Press [OK] again to start printing.
(refer to the print functions manual)
P M
- RINT
P S
- RINT TATUS
I
- NTERFACE
P
ARALLEL
USB
N
ETWORK
N
ET
TCP/IP
A
PPLE TALK
P
RES STATUS PAGE
E
- MULATION
A
CCESS TO FUNCTIONS
G
UIDE TO FUNCTIONS
Functions
M
ENU AP
P
AGE
W
ARE
and
MENU -
Description of the function
Print out the menu guide
Print out the printer configuration
Parallel interface configuration
USB interface configuration
Network interface configuration
Turn this menu on if you are using the Netware
protocol
Turn this menu on if you are using the TCP/IP protocol
Turn this menu on if you are networking with a
Macintosh
When this menu is turned on, the network
configuration page is printed out at the same time as
the printer status page
Select emulation type
2-12
Getting started
keys (access the menu shown by
- PRINT MENU STRUCTURE