Sagem MF 5890DN User Manual page 107

Operation
By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move
the scanning zone as shown on the figure below.
Select the X and Y coordinates with
Set the required coordinates with the numeric keypad or
by pressing key OK.
The
using keys
You can also directly adjust the desired contrast using the key, press this
times until the required adjustment is obtained without using
The LUMINOSITY parameter is used to make your original document lighter or darker.
Adjust the brightness required using keys
OK key.
The BINDING parameter is used to choose the long or short side according to the type of
binding of your document. Make your choice using keys
choice with the OK key.
Caution -
Use keys
modify.
Validate your setting by pressing the OK key.
Select NORMAL or THICK paper using
Validate your setting by pressing the OK key.
Remark: 1) When
2) Use the manual feeder for paper with a weight greater than 90 g/m
y
x
parameter is used to select the photocopy contrast. Adjust the contrast
CONTRAST
, then validate the choice with the OK key.
and
All settings made using this menu become default settings of the machine.
or of the browser to scroll the setting described below that you want to
851 OK - ADVANCED FCT / SCAN. & PRINT / PAPER
THICK
paper type is selected, the print speed is slowed down.
5-19
or keys.
845 OK - ADVANCED FCT / COPY / CONTRAST
846 OK - ADVANCED FCT / COPY / LUMINOSITY
and , then validate the choice with the
847 OK - ADVANCED FCT / COPY / BINDING
85 OK - ADVANCED FCT / SCAN. & PRINT
and keys.
Scanned area
or . Confirm your setting
key several
846.
and , then validate the
2
.