Installation Problems; Drive Setup - ABB RCNA-01 User Manual

Name Colour
GREEN
GREEN
RED
RED

Installation problems

Verify all the connections on the module:
• Check that the ControlNet cables are connected to the BNC
connectors as described in chapter
• Check that the RCNA-01 module is properly inserted into the
option slot.
• Check the fastening of the RCNA-01 module with the 2 screws.

Drive setup

The fieldbus parameter group is not shown on the panel:
• Enable the RCNA-01 by setting the appropriate drive
parameter.
The RCNA-01 is using default values:
• Verify that the fieldbus parameter group is set up correctly. If so,
turn off and on the power to the drive or issue a 'Fieldbus
Adapter parameter refresh' command. This will make the
module re-read its setup parameters.
Module
status
Channel B
Function
Steady - Link functional
Flashing - Waiting for PLC connection
Steady - Link lost permanently.
Flashing - Link lost temporarily
Electrical
63
Host Indication
Channel A
installation.
Fault tracing