Programming; Overview; Configuring The System; Controlnet Connection Configuration - ABB RCNA-01 User Manual

Programming

Overview

This chapter gives information on configuring the RCNA-01
ControlNet Adapter module.

Configuring the system

After the RCNA-01 ControlNet Adapter module has been
mechanically and electrically installed according to the instructions
in chapters
drive must be prepared for communication with the module and
Scanner.
Please refer to the Scanner documentation for information on
configuring the system for communication with the RCNA-01.
Configuration (EDS) files for the RCNA-01 are available at
www.abb.com.

ControlNet connection configuration

The detailed procedure of activating the module for
communication with the drive is dependent on the drive type.
(Normally, a parameter must be adjusted to activate the
communication. See the drive documentation.)
As communication between the drive and the RCNA-01 is
established, several configuration parameters are copied to the
drive. These parameters (shown in
configuration
necessary. The alternative selections for these parameters are
discussed in more detail below the table.
Note: The new settings take effect only when the module is
powered up or when the module receives a 'Fieldbus Adapter
parameter refresh' command from the drive.
Mechanical installation
parameters) must be checked first and adjusted if
and Electrical installation, the
Table 1. The RCNA-01
23
Programming